We provide real 642-980 exam questions and answers braindumps in two formats. Download PDF & Practice Tests. Pass Cisco 642-980 Exam quickly & easily. The 642-980 PDF type is available for reading and printing. You can print more and practice many times. With the help of our Cisco 642-980 dumps pdf and vce product and material, you can easily pass the 642-980 exam.


2026 New 642-980 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/642-980/

Q1. Which statement would explain why the overlay interface on an OTV edge device is not in the up state? 

A. The site identifiers are identical within a multihomed site. 

B. Multicast groups are not mapped to a range of SSM addresses to carry the multicast traffic. 

C. An adjacency server is not configured for connectivity over a multicast transport. 

D. The OTV IS-IS metrics do not match across all adjacent OTV edge devices. 

Answer: B 

Q2. On the secondary vPC switch, under which circumstance does the vPC autorecovery feature not bring up the vPC member ports? 

A. Peer link fails, and subsequently, the peer-keepalive link fails. 

B. Peer link is up, and the peer-keepalive link fails. 

C. Both vPC peers are reloaded, and the primary does not come back up. 

D. Peer link fails, and subsequently, the primary switch fails. 

Answer: B 

Q3. Which two commands will show all the OTV edge devices and their MAC addresses in the local site? (Choose two.) 

A. show otv overlay 

B. show otv site 

C. show otv vlan 

D. show otv adjacency 

E. show mac address-table 

Answer: BD 

Q4. Refer to the exhibit. 

When your customers have NPV problems, which three actions should you take? (Choose three.) 

A. Verify that the NPV core switch supports NPIV and that it is enabled. 

B. Verify that all ports are properly configured and connected. 

C. Ensure that the VLAN values are configured on both sides of the NPV core switch. 

D. Verify the status of the servers and external interfaces, using the show npv server status command. 

E. Ensure that the VSAN value that is configured on the device links is correct. 

F. For all the device links, ensure that the port mode on the NPV device is in Full_port mode. 

Answer: ABE 

Q5. Fibre Channel traffic on VSAN 12 between N5K2 and MDS9124-2 is degraded. Which statement explains the cause of this degradation? 

A. Performance is decreased by half due to the incorrect port type being used. 

B. The load-balancing scheme for VSAN 12 should be src-id/dst-id. 

C. B2B credits on N5K2 should be increased to 128. 

D. A VSAN port channel must be configured between N5K2 and MDS9124-2. 

Answer: D 

Q6. Refer to the output. 

feature otv 

otv site-vlan 2 

otv site-identifier 256 

!

interface ethernet 2/0 

ip address 192.0.2.1/24 

ip igmp version 3 

! 

interface ethernet 2/1 

ip address 192.0.2.2/24 

ip igmp version 3 

! 

interface Overlay1 

otv control-group 239.1.1.1 

otv join-interface ethernet 2/0 

otv extend-vlan 3-100 

! 

interface Overlay2 

otv control-group 239.1.1.1 

otv join-interface ethernet 2/1 

otv extend-vlan 101-115 

Which command best represents where the control plane configurations are applied? 

A. switch(config-if-overlay)# otv isis hello-interval 30 

B. switch(config-if)# otv isis hello-interval 30 

C. switch(config-vlan)# otv isis hello-interval 30 

D. switch(config)# otv isis hello-interval 30 

Answer: A 

Q7. Which two describe the correct requirements for non-disruptive IOS ISSU on Cisco Nexus 7000 Series Switches? (Choose two.) 

A. updated kickstart and system images must be staged in bootflash on single-supervisor switches 

B. updated kickstart and system images must be staged in bootflash on dual-supervisor switches 

C. low version skew 

D. dual supervisors 

E. clock synchronization 

Answer: CD 

Q8. Which statement is true regarding LACP configuration? 

A. With LACP, you can bundle up to 16 interfaces in a channel group. 

B. LACP configuration is global and can be only configured by admin. 

C. After removing LACP configuration, you need to reboot the device. 

D. You can disable LACP while any LACP configurations are present. 

Answer: A 

Q9. Which statement is true regarding the admin VDC? 

A. All licensed features and feature sets must be enabled from the admin VDC. 

B. Fabric extenders connectedto the admin VDC must be statically pinned. 

C. Only the mgmt 0 interface is allocated to the admin VDC. 

D. All interfaces other than mgmt 0 are allocated to the default VDC. 

E. The admin context can only be created on Supervisor 2/2E. 

F. The admin VDC is a new feature in Cisco NX-OS version 6.0. 

Answer: C 

Q10. Which three commands will show all the MAC addresses learned from remote sites in an OTV overlay? (Choose three.) 

A. show otv arp-nd-cache 

B. show otv route overlay 

C. show otv vlan 

D. show ip arp 

E. show mac address-table 

F. show otv site 

Answer: ABE