Practical of 200-150 free practice test materials and tutorials for Cisco certification for customers, Real Success Guaranteed with Updated 200-150 pdf dumps vce Materials. 100% PASS DCICN Introducing Cisco Data Center Networking exam Today!
2026 New 200-150 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-150/
Q1. Which two layers of the OSI model are combined in the Internet protocol suite application layer? (Choose two.)
A. 2
B. 3
C. 4
D. 5
E. 6
F. 7
Answer: D,E
Explanation:
http://en.wikipedia.org/wiki/Internet_protocol_suite
Q2. Which field in an Ethernet II frame performs the same function as the DSAP field in an
802.3 Ethernet frame?
A. Start of frame
B. EtherType
C. Frame check sequence
D. Subnetwork Access Protocol
E. Logical Link Control
Answer: B
Q3. Which statement Is true regarding configuring NPV mode?
A. When you enable NPV, the system configuration is erased and t* switch reboots
B. When you enable NPV. the system configuration is not erased and the does not switch reboot
C. In Exhibit 3 NPV is enabled. but Server interface to the external switch is not bed to correct vfc 2/1.
D. m NPV mode, the core switch relays traffic from server-side ports to the edge switch and core swtich provides N ports.
Answer: A
Explanation: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/configuration/guid e/cli_rel_4_0_1a/CLIConfigurationGuide/npv.html
Q4. Which two networking devices forward data based on destination MAC address? (Choose two.)
A. Repeater
B. Bridge
C. Switch
D. Router
E. Hub
Answer: B,C
Explanation:
http://www.cisco.com/en/US/prod/collateral/switches/ps9441/ps9670/white_paper_c11- 465436.html
Q5. Which VTP mode disallows the creation of local VLANs?
A. transparent
B. tunneling
C. server
D. client
E. off
F. native
Answer: D
Explanation:
"A VTP client behaves like a VTP server and transmits and receives VTP updates on its trunks, but you cannot create, change, or delete VLANs on a VTP client. VLANs are configured on another switch in the domain that is in server mode." http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_52_se/configuration/guide/swvtp.html#wp1205076
Q6. Which device would you select to partition a network into VLANs?
A. repeater
B. bridge
C. switch
D. router
E. hub
Answer: C
Q7. A network engineer wants to apply for new license key file. Which command should be used to obtain the switch serial number?
A. MDS-A# show license serial-number
B. MDS- A# show running-config | include serial-number
C. MDS- A# show host-id
D. MDS- A# show license host-id
Answer: D
Q8. What are two features of a bridge? (Choose two.)
A. Reliable transmission
B. Operate at OSI Layer 2
C. Operate at OSI Layer 3
D. Create multiple broadcast domains
E. Create multiple collision domains
F. Flood input packets to all ports
G. Drop IP packets with invalid destination ports
Answer: B,E
Explanation:
"- a bridge is a two interfaces device that creates 2 collision domains, since it forwards the traffic it receives from one interface only to the interface where the destination layer 2 device (based on his mac address) is connected to. A bridge is considered as an "intelligent hub" since it reads the destination mac address in order to forward the traffic only to the interface where it is connected"
https://learningnetwork.cisco.com/thread/1734
Q9. What are three reasons that switches supersede bridges? (Choose three.)
A. Smaller frame buffers decrease latency.
B. Forward, filter, or flood frames.
C. Multiple simultaneous communications between ports.
D. Larger inspection engine allows for higher throughput.
E. Switches have many ports.
Answer: B,C,E
Explanation:
http://docwiki.cisco.com/wiki/Bridging_and_Switching_Basics
Q10. Refer to the exhibit.
What two conclusions can be mode based upon the output? (Choose two.)
A. regular fromat WWNs are being used
B. the command show flogl database was run
C. the command show fcns database vsan 1 was run
D. registered name formate WWNs are being used
E. extended format WWNs are being used.
Answer: B,E