Master the 300 075 dump Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) content and be ready for exam day success quickly with this Examcollection cisco 300 075 dumps. We guarantee it!We make it a reality and give you real 300 075 dump questions in our Cisco 300 075 dump braindumps.Latest 100% VALID Cisco 300 075 ciptv2 Exam Questions Dumps at below page. You can use our Cisco cisco 300 075 braindumps and pass your exam.
2026 New 300-075 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-075/
Q1. Which E.164 transformation pattern represents phone numbers in Germany?
A. +49.!
B. 49.!
C. 49.!
D. +49.X
Answer: A
Q2. When device mobility mode is enabled or disabled for a cluster, to which does the cluster setting apply?
A. all phones in the cluster that support device mobility
B. all phones in the cluster that subscribed to device mobility
C. mobile phones in the cluster that support device mobility
D. mobile phones in the cluster that are in default mode
Answer: A
Q3. What is the purpose of a SAF Client?
A. To decode address information and route calls to and from the end points
B. To pass IP information from the CUCM to the endpoint
C. To learn about and advertise or subscribe information about SAF network services
D. To reside in the Cisco IOS software, and to communicate with the SAF forwarder
Answer: C
Q4. Which configuration command disables the secondary dial tone on the branch office ISR for users calling from the PSTN into the branch office during a WAN failure?
A. direct-inward-dial
B. voice translation-rule
C. incoming called-number
D. application
Answer: A
Q5. Which option best describes a service that assembles a network model from configured locations and link data in one or more clusters?
A. LBM
B. Weight
C. LBM Hub
D. Shadow
Answer: A
Q6. Which two are gatekeeper-controlled trunk options that support gatekeeper call administration control? (Choose two.)
A. H.323
B. H.245
C. H.225
D. intercluster
E. intracluster
Answer: C,D
Q7. Which trunk should you use in an H.323 gatekeeper-controlled network?
A. H.323
B. H.225
C. SIP
D. Intercluster
E. MGCP FXO trunk
F. MGCP T1/E1 trunk
Answer: B
Q8. Which statement is not true about GARP?
A. GARP attacks require access to the target LAN or VLAN.
B. GARP can be used for a man-in-the-middle attack.
C. GARP is normally used for HSRP.
D. GARP can be disabled at Cisco IP phones.
Answer: C
Explanation:
Incorrect Answer: A, B, D
GARP (Gratuitous ARP) announce the presence of IP Phone on the network.
Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/security/4_0_1/secuphne.html
Q9. Refer to the exhibit. A user in RTP calls a phone in San Jose during congestion with Call Forward No Bandwidth (CFNB) configured to reach cell phone 4085550150. The user in RTP sees the message "Not Enough Bandwidth" on their phone and hears a fast busy tone. Which two conditions can correct this issue? (Choose two.)
A. The calling phone (RTP) needs to have AAR Group value of AAR under the AAR Settings.
B. The called phone (San Jose) needs to have AAR Group value of AAR under the AAR Settings.
C. The calling phone (RTP) needs to have the AAR destination mask of 914085550150 configured under the AAR Settings.
D. The calling phone (RTP) needs to have the AAR destination mask of 4085550150 configured under the AAR Settings.
E. The called phone (San Jose) needs to have the AAR destination mask of 914085550150 configured under the AAR Settings.
F. The called phone (San Jose) needs to have the AAR destination mask of 4085550150 configured under the AAR Settings.
Answer: B,F
Explanation:
Incorrect Answer: A, C, D, E Automated alternate routing (AAR) provides a mechanism to reroute calls through the PSTN or other network by using an alternate number when Cisco Unified Communications Manager blocks a call due to insufficient location bandwidth. With automated alternate routing, the caller does not need to hang up and redial the called party. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucmbe/admin/8_6_1/ccmcfg/b03aar.ht ml
Q10. The relationship between a Region and a Location is that the Region codec parameter is combined with Location bandwidth when communicating with other Regions.
A. FALSE
B. TRUE
Answer: A
Explanation:
Locations work in conjunction with regions to define the characteristics of a network link. Regions define the type of compression (G.711, G.722, G.723, G.729, GSM, or wideband) that is used on the link, and locations define the amount of available bandwidth for the link Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02cac.html #wp1033331