It is impossible to pass Cisco 300 075 pdf exam without any help in the short term. Come to Exambible soon and find the most advanced, correct and guaranteed Cisco 300 075 pdf practice questions. You will get a surprising result by our Most up-to-date Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) practice guides.
2026 New 300-075 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-075/
Q1. Refer to the exhibit.
When the user of a phone registered to the Cisco Unified Communications Manager places a call to 3001 when the SAF network is down, what happens?
A. The call fails.
B. The call is rerouted to the PSTN with the constructed PSTN number as +442288223001
C. The call is rerouted to the PSTN with the constructed PSTN number as 442288223001
D. The call is rerouted to the PSTN with the constructed PSTN number as 0002288223001
E. The call is rerouted to the PSTN with the constructed PSTN number as +0002288223001
Answer: A
Explanation:
Incorrect Answer: B, C, D When the SAF forwarder loses network connection with its call-control entity, the SAF forwarder withdraws those learned patterns that were published by the call control entity. In this case, CCD requesting service marks those learned patterns as unreachable via IP, and the calls get routed through the PSTN gateway. Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmfeat/fscallcontrol discovery.html
Q2. Which two locations are the best locations that an end user can use to determine if an IP phone is working in SRST mode? (Choose two.)
A. Cisco Unified Communications Manager Administration
B. IP phone display
C. Cisco Unified SRST Router
D. Cisco Unified MGCP Fallback Router
E. physical IP phone settings
Answer: B,E
Explanation:
Incorrect Answer: A, C, D IP Phone display and Physical phone IP settings are two locations were an end user can determine if an IP phone is working in SRST mode. Link: http://my.safaribooksonline.com/book/telephony/1587050757/survivable-remote-site-telephony-srst/529
Q3. Which solution is needed to enable presence and extension mobility to branch office phones during a WAN failure?
A. SRST with MGCP fallback
B. SRST without MGCP fallback
C. Cisco Unified Communications Manager Express in SRST mode
D. SRST with VoIP dial peers to Cisco Unified Communications Manager Express
Answer: C
Q4. Refer to the exhibit:
The exhibit shows a SAF Forwarder configuration attached to a Cisco Unified Communications Manager.
Which minimum configuration for a Cisco Unified Communications Manager Express SAF Forwarder is needed to establish a SAF neighbor relationship with this SAF Forwarder?
A. router eigrp SAFiservice-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-familyvoice service safprofile trunkroute 1session protocol sip interface Loopback1 transport tcp port 5060!
B. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit- service-family!voice service safprofile trunk-route 1session protocol sip interface Loopback1 transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2!channel 1 vrouter SAF asystem 1subscribe callcontrol wildcardedpublish callcontrol 1!
C. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!
D. None of above configurations contain sufficient information.
Answer: C
Explanation:
Incorrect Answer: A, B, D only following configuration is enough router eigrp SAF service-family ipv4 autonomous-system 1 exit-service-family link:
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6554/ps6599/ps10822/whitepaper_c11-636604.html
Q5. Which statement is true regarding the configuration of SAF Forwarder?
A. In a multisite dial plan, SAF Forwarders may exist in multiple autonomous systems.
B. The client label that is configured in Cisco Unified Communications Manager must match the configuration on the SAF Forwarder router.
C. There should not be multiple nodes of Cisco Unified Communications Manager clusters acting as SAF clients.
D. The destination IP address must match the loopback address of the SAF router.
Answer: A
Q6. How do RSVP-enabled locations differ from Cisco Unified Communications Manager locations?
A. RSVP is configured in the ISR independent of Cisco Unified Communications Manager.
B. RSVP enables AAR within Cisco Unified Communications Manager.
C. RSVP is topology aware.
D. RSVP is configured in Cisco Unified Communications Manager independent of the ISR.
Answer: C
Q7. Scenario There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phones. The Cisco VCS and TMS control the Cisco TelePresence Conductor, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DNS Servers
Device Pool
Expressway
ILS
Locations
MRA
Speed Dial
SIP Trunk
The intercluster URI call routing no longer allows calls between sites. What is the reason why this would happen? (Choose two)
A. Wrong SIP domain configured.
B. User is not associated with the device.
C. IP or DNS name resolution issue.
D. No SIP route patterns for cisco.lab exist.
Answer: C,D
Q8. DRAG DROP
Answer:
Q9. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phones. The Cisco VCS and TMS control the Cisco TelePresence Conductor, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DNS Servers
Device Pool
Expressway
ILS
Locations
MRA
Speed Dial
SIP Trunk
What two tasks must be completed in order to support calls between the VCS controlled endpoints and the Cisco Unified CM endpoints? (Choose two.)
A. Media Resource Group List.
B. Configure a SIP trunk on the Cisco Unified CM to point to the Cisco VCS.
C. Configure a neighbor zone on the Cisco Unified CM to point to the Cisco VCS.
D. Configure a SIP trunk on the Cisco VCS to point to the Cisco Unified CM.
E. Configure a neighbor zone on the Cisco VCS to point to the Cisco Unified CM.
Answer: B,D
Q10. Which statement is not true about GARP?
A. GARP attacks require access to the target LAN or VLAN.
B. GARP can be used for a man-in-the-middle attack.
C. GARP is normally used for HSRP.
D. GARP can be disabled at Cisco IP phones.
Answer: C
Explanation:
Incorrect Answer: A, B, D
GARP (Gratuitous ARP) announce the presence of IP Phone on the network.
Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/security/4_0_1/secuphne.html