Want to know Ucertify cisco 300 115 dumps Exam practice test features? Want to lear more about Cisco Implementing Cisco IP Switched Networks certification experience? Study Realistic Cisco 300 115 switch pdf answers to Improve 300 115 vce questions at Ucertify. Gat a success with an absolute guarantee to pass Cisco ccnp 300 115 (Implementing Cisco IP Switched Networks) test on your first attempt.


2026 New 300-115 Exam Dumps with PDF and VCE Free: https://www.surepassexam.com/300-115-exam-dumps.html

Q1. After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state. Which option describes what causes the port to go into the errdisable state?

A. Normal UDLD operations that prevent traffic loops.

B. UDLD port is configured in aggressive mode.

C. UDLD is enabled globally.

D. UDLD timers are inconsistent.

Answer: B

Q2. After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible. Which vendor-neutral protocol could be used to resolve this issue?

A. Local Area Mobility

B. Link Layer Discovery Protocol

C. NetFlow

D. Directed Response Protocol

Answer: B

Q3. When you configure a private VLAN, which type of port must you configure the gateway router port as?

A. promiscuous port

B. isolated port

C. community port

D. access port

Answer: A

Q4. On which interface can port security be configured?

A. static trunk ports

B. destination port for SPAN

C. EtherChannel port group

D. dynamic access point

Answer: A

Q5. Which statement about Cisco Discovery Protocol configuration on a Cisco switch is true?

A. CDP is enabled by default and can be disabled globally with the command no cdp run.

B. CDP is disabled by default and can be enabled globally with the command cdp enable.

C. CDP is enabled by default and can be disabled globally with the command no cdp enable.

D. CDP is disabled by default and can be enabled globally with the command cdp run.

Answer: A

Q6. Which statement describes what happens when a port configured with root guard receives a superior BPDU?

A. The port goes into errdisabled state and stops forwarding traffic.

B. The port goes into BPDU-inconsistent state and stops forwarding traffic.

C. The port goes into loop-inconsistent state and stops forwarding traffic.

D. The port goes into root-inconsistent state and stops forwarding traffic.

Answer: D

Q7. Refer to the exhibit.

Which EtherChannel negotiation protocol is configured on the interface f0/13 – f0/15?

A. Link Combination Control Protocol

B. Port Aggregation Protocol

C. Port Combination Protocol

D. Link Aggregation Control Protocol

Answer: B

Q8. Refer to the exhibit.

What is the result of the SPAN configuration on a Cisco switch?

A. Configure a SPAN session to monitor the received traffic on interface g0/4 only for VLAN 3.

B. Configure a SPAN session to monitor the received traffic on interface g0/4 for all VLANs except VLAN 3.

C. Configure a SPAN session to monitor the received traffic on interface g0/5 only for VLAN 3.

D. Configure a SPAN session to monitor the received traffic on interface g0/5 for all VLANs except VLAN 3.

Answer: A

Q9. Which database is used to determine the validity of an ARP packet based on a valid IP-to- MAC address binding?

A. DHCP snooping database

B. dynamic ARP database

C. dynamic routing database

D. static ARP database

Answer: A

Q10. A switch is added into the production network to increase port capacity. A network engineer is configuring the switch for DHCP snooping and IP Source Guard, but is unable to configure ip verify source under several of the interfaces. Which option is the cause of the problem?

A. The local DHCP server is disabled prior to enabling IP Source Guard.

B. The interfaces are configured as Layer 3 using the no switchport command.

C. No VLANs exist on the switch and/or the switch is configured in VTP transparent mode.

D. The switch is configured for sdm prefer routing as the switched database management template.

E. The configured SVIs on the switch have been removed for the associated interfaces.

Answer: B