Proper study guides for Renew Cisco Implementing Cisco IP Switched Networks certified begins with Cisco 300 115 switch preparation products which designed to deliver the 100% Guarantee ccnp routing and switching switch 300 115 official cert guide questions by making you pass the ccnp routing and switching switch 300 115 official cert guide test at your first time. Try the free cisco 300 115 dumps demo right now.


2026 New 300-115 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-115/

Q1. In a Cisco switch, what is the default period of time after which a MAC address ages out and is discarded?

A. 100 seconds

B. 180 seconds

C. 300 seconds

D. 600 seconds

Answer: C

Q2. What is the maximum number of 10 Gigabit Ethernet connections that can be utilized in an EtherChannel for the virtual switch link?

A. 4

B. 6

C. 8

D. 12

Answer: C

Q3. A network engineer tries to configure storm control on an EtherChannel bundle. What is the result of the configuration?

A. The storm control settings will appear on the EtherChannel, but not on the associated physical ports.

B. The configuration will be rejected because storm control is not supported for EtherChannel.

C. The storm control configuration will be accepted, but will only be present on the physical interfaces.

D. The settings will be applied to the EtherChannel bundle and all associated physical interfaces.

Answer: D

Q4. What is the maximum number of virtual MAC addresses that GLBP allows per group?

A. 2

B. 4

C. 6

D. 8

Answer: B

Q5. What happens on a Cisco switch that runs Cisco IOS when an RSTP-configured switch receives 802.1d BPDU?

A. 802.1d does not understand RSTP BPDUs because they are different versions, but when a RSTP switch receives an 802.1d BPDU, it responds with an 802.1d BPDU and eventually the two switches run 802.1d to communicate.

B. 802.1d understands RSTP BPDUs because they are the same version, but when a RSTP switch receives a 802.1d BPDU, it responds with a 802.1d BPDU and eventually the two switches run 802.1d to communicate.

C. 802.1d does not understand RSTP BPDUs because they are different versions, but when a RSTP switch receives a 802.1d BPDU, it does not respond with a 802.1d BPDU.

D. 802.1d understands RSTP BPDUs because they are the same version, but when a RSTP switch receives a 802.1d BPDU, it does not respond with a 802.1d BPDU and eventually the two switches run 802.1d to communicate.

Answer: A

Q6. Which SDM template is the most appropriate for a Layer 2 switch that provides connectivity to a large number of clients?

A. VLAN

B. default

C. access

D. routing

Answer: A

Q7. Refer to the exhibit.

All ports are members of VLAN 10. Considering the default cost of upstream bridges to the root bridge is equal, which option will be the new root port for VLAN 10?

A. interface f0/13

B. interface f0/14

C. interface f0/15

D. interface f0/21

Answer: D

Q8. Which feature must be enabled to eliminate the broadcasting of all unknown traffic to switches that are not participating in the specific VLAN?

A. VTP pruning

B. port-security

C. storm control

D. bpdguard

Answer: A

Q9. Which command would a network engineer apply to error-disable a switchport when a packet-storm is detected?

A. router(config-if)#storm-control action shutdown

B. router(config-if)#storm-control action trap

C. router(config-if)#storm-control action error

D. router(config-if)#storm-control action enable

Answer: A

Q10. Which option describes a limitation of LLDP?

A. LLDP cannot provide information about VTP.

B. LLDP does not support TLVs.

C. LLDP can discover only Windows servers.

D. LLDP can discover up to two devices per port.

Answer: A