Your success in Cisco 300-365 is our sole target and we develop all our 300-365 braindumps in a way that facilitates the attainment of this target. Not only is our 300-365 study material the best you can find, it is also the most detailed and the most updated. 300-365 Practice Exams for Cisco CCNP Wireless 300-365 are written to the highest standards of technical accuracy.


2026 New 300-365 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-365/

Q1. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking? 

A. Uses existing LWAPP-enabled Cisco Unified Networking components. 

B. Proprietary client hardware or software is required. 

C. Better accuracy and precision. 

D. Reduced calibration effort. 

Answer: B 

Q2. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem? 

A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones. 

B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers. 

C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller. 

D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band. 

Answer: B 

Q3. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs? 

A. 802.11 

B. RRM 

C. High Density 

D. General 

Answer: B 

Q4. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 

Q5. You are deploying a combination of Cisco Unified Wireless IP Phones 7921G and 7925G at your branch offices in a centralized call processing environment that requires high availability at branch locations. Which three components need to be verified before the wireless IP phones can be deployed? (Choose three.) 

A. Sufficient SRST license support at each branch location 

B. Support for local voice mail 

C. Branch gateways support MoH 

D. Properly configured QoS over the IP WAN links 

E. Support for single number reach 

F. Support for E.164 dialing 

G. Sufficient IP phone licenses in the Cisco Unified Communications Manager cluster 

Answer: A,D,G 

Q6. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue? 

A. controller IGMP snooping 

B. unicast AP Multicast Mode 

C. broadcast forwarding 

D. multicast AP Multicast Mode 

Answer: B 

Q7. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.) 

A. All ports participate in the LAG by default when LAG is enabled on the controller, y 

B. Dynamic interfaces and management are moved to port 1 

C. Primary and secondary ports are needed for each interface. 

D. Multiple untagged interfaces to the same port are not allowed. 

E. EtherChannel must be configured for mode "on" on the switch. 

F. Only one functional physical port is needed to continue to pass traffic. 

G. Multiple LAGs are permitted on the controller. 

H. The WLC does not need to be rebooted to enable the LAG configuration. 

Answer: A,D,E,F 

Q8. A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped? 

A. 4 

B. 3 

C. 5 

D. 2 

E. 1 

Answer: C 

Q9. When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.) 

A. Upstream marked as Best Effort. 

B. Upstream marked as ToS CS4. 

C. Upstream marked as DSCP EF. 

D. Downstream marked as DSCP EF. 

E. Downstream marked as Best Effort. 

F. Downstream marked as Silver. 

Answer: C,E 

Q10. Scenario 

There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are. 

What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.) 

A. Change the AP in the Employees-East-Wing AP Group. 

B. Change the IP Address in the east-wing interface. 

C. Change the VLAN Identifier in the east-wing interface. 

D. Enable Dynamic AP Management in the east-wing interface. 

E. Change the Port Number to 2 in the east-wing interface. 

F. Add the Primary Controller and IP address to the 3700-East-Wing AP. 

G. Change the SSID in the Employees-East-Wing AP Group. 

H. Change the Interface/Interface Group In the Employees-East-Wing AP Group. 

Answer: D,F,G,H