Validated of 300-365 test questions materials and dump for Cisco certification for IT specialist, Real Success Guaranteed with Updated 300-365 pdf dumps vce Materials. 100% PASS Deploying Cisco Wireless Enterprise Networks exam Today!


2024 New 300-365 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-365/

Q1. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this? 

A. Cisco MSE as NetFlow exporter 

B. Prime Infrastructure 1.0 or later 

C. Cisco NAC as NetFlow exporter 

D. Cisco ISE as NetFlow exporter 

Answer: B 

Q2. What are two functions of the RAP in a mesh network? (Choose two.) 

A. It provides a wired connection for the wireless mesh APs. 

B. It adds capacity and resilience to a mesh area. 

C. it creates a centralized management location for the mesh network. 

D. it reduces the hop count to the wireless network that is connected to the edge. 

E. it routes traffic from the wireless mesh to the wired network. 

Answer: B,D 

Q3. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking? 

A. Uses existing LWAPP-enabled Cisco Unified Networking components. 

B. Proprietary client hardware or software is required. 

C. Better accuracy and precision. 

D. Reduced calibration effort. 

Answer: B 

Q4. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue? 

A. controller IGMP snooping 

B. unicast AP Multicast Mode 

C. broadcast forwarding 

D. multicast AP Multicast Mode 

Answer: B 

Q5. A wireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings: -72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received. 

Which two commands achieve these settings? (Choose two.) 

A. config advanced 802.11a coverage data fail-percentage 25 

B. config advanced 802.11b optimized-roaming enable 

C. config advanced 802.11b coverage data rssi-threshold -72 

D. config advanced 802.11a optimized-roaming enable 

E. config advanced 802.11a coverage data rssi-threshold -72 

Answer: A,D 

Q6. Scenario 

There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are. 

What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.) 

A. Change the AP in the Employees-East-Wing AP Group. 

B. Change the IP Address in the east-wing interface. 

C. Change the VLAN Identifier in the east-wing interface. 

D. Enable Dynamic AP Management in the east-wing interface. 

E. Change the Port Number to 2 in the east-wing interface. 

F. Add the Primary Controller and IP address to the 3700-East-Wing AP. 

G. Change the SSID in the Employees-East-Wing AP Group. 

H. Change the Interface/Interface Group In the Employees-East-Wing AP Group. 

Answer: D,F,G,H 

Q7. A customer has implemented a wireless network that requires tuning for High Density applications utilizing the RX-SOP feature. They are experiencing a high noise floor (average of -65 dBm) and expect that to decrease significantly. A sampling of radios determine that most Access Points have neighbors on the same channel at a power level of -75 dBm. Which value should the customer use to start tuning RX-SOP? 

A. -60 dBm 

B. -65dBm 

C. -70 dBm 

D. -75 dBm 

E. -80 dBm 

Answer: C 

Q8. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group? 

A. 224.0.0.13 

B. 224.0.1.39 

C. 224.0.0.14 

D. 224.0.140 

Answer: D 

Q9. What is the best practice for setting the WLC v7.0 use of WLAN QoS settings to support SIP phones on a VoWLAN? 

A. Configure SIP with static CAC only with SIP call snooping. 

B. Configure SIP with static CAC only without SIP call snooping. 

C. Configure SIP with load-based CAC only with SIP call snooping. 

D. Configure SIP with load-based CAC only without SIP call snooping. 

E. Configure SIP with load-based CAC and TSPEC only with SIP call snooping. 

Answer: A 

Q10. A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured. How many image transfers between the WLC and APs will occur? 

A. 7 

B. 1 

C. 5 

D. 2 

Answer: D