Our pass rate is high to 98.9% and the similarity percentage between our 300-365 study guide and real exam is 90% based on our seven-year educating experience. Do you want achievements in the Cisco 300-365 exam in just one try? I am currently studying for the Cisco 300-365 exam. Latest Cisco 300-365 Test exam practice questions and answers, Try Cisco 300-365 Brain Dumps First.


2026 New 300-365 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-365/

Q1. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem? 

A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones. 

B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers. 

C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller. 

D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band. 

Answer: B 

Q2. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs? 

A. 802.11 

B. RRM 

C. High Density 

D. General 

Answer: B 

Q3. The customer has deployed C7960 phones with clients connected to them. What switch feature could be enabled to distinguish IP voice traffic from client data traffic? 

A. VoiceVLAN 

B. QoS routing 

C. WME 

D. Weighted Queuing 

E. QBSS 

Answer: A 

Q4. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead? 

A. 10 Seconds 

B. 60 Seconds 

C. 15 Seconds 

D. 30 Seconds 

Answer: D 

Q5. A network engineer must configure a 5 GHz network to allow for the greatest density of radios possible with the least amount of co-channel interference. Which configuration best fulfills this requirement? 

A. Set 802.11 h Local Power constraint to 25 dBm. 

B. Set DCA to 20 MHz channels and enable Extended UNII-2 channels. 

C. Enable Event Driven RRM in 5 GHz with a sensitivity of High, n 

D. Configure TPC Power Threshold to -80 dBm and set interference Optimal Mode (TPCv2). 

Answer: B 

Q6. You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages are failing between the two devices. What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP? 

A. UDP 16113 

B. TCP 1613 

C. TCP 16113 

D. UDP 1613 

Answer: C 

Q7. RAG DROP 

Drag the QoS values from the left and drop them in the correct descending order of priority on the right. 

Answer:  

Q8. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group? 

A. 224.0.0.13 

B. 224.0.1.39 

C. 224.0.0.14 

D. 224.0.140 

Answer: D 

Q9. On which AP radio or radios is Cisco WGB association supported? 

A. 2.4 GHz only 

B. 2.4 or 5 GHz only 

C. 2.4, 5, or 4.9 GHz 

D. 5 GHz only 

Answer: B 

Q10. A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped? 

A. 4 

B. 3 

C. 5 

D. 2 

E. 1 

Answer: C