Master the ccnp 300 101 dumps ROUTE Implementing Cisco IP Routing content and be ready for exam day success quickly with this Testking 300 101 route pdf study guide. We guarantee it!We make it a reality and give you real ccnp routing and switching route 300 101 official cert guide questions in our Cisco ccnp 300 101 pdf braindumps.Latest 100% VALID Cisco ccnp route 300 101 dumps Exam Questions Dumps at below page. You can use our Cisco ccnp route 300 101 braindumps and pass your exam.
2026 New 300-101 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-101/
P.S. Realistic 300-101 answers are available on Google Drive, GET MORE: https://drive.google.com/open?id=1VVsMJd1T1ylej0aePOIREXo7V31c7pn0
New Cisco 300-101 Exam Dumps Collection (Question 11 - Question 20)
Question No: 11
For a GRE tunnel to be up between two routers, which of the following must be configured?
A. Loopback Interface
B. IP reachability between the loopback interfaces
C. Dynamic Routing between routers.
D. Tunnel interfaces must be in the same subnet.
Answer: D
Question No: 12
Refer to exhibit.
What is indicated by the show ip cef command for an address?
A. CEF is unable to get routing information for this route.
B. CEF cannot switch packet for this route and passes it to the next best switching method.
C. A valid entry and is pointed to hardware based forwarding.
D. CEF cannot switch packet for this route and drops it.
Answer: B
Explanation: Glean adjacency u2013 in short when the router is directly connected to hosts the FIB table on the router will maintain a prefix for the subnet rather than for the individual host prefix. This subnet prefix points to a GLEAN adjacency.
Punt adjacency u2013 When packets to a destination prefix canu2021t be CEF Switched, or the feature is not supported in the CEF Switching path, the router will then use the next slower switching mechanism configured on the router.
Question No: 13
After reviewing the EVN configuration, a network administrator notices that a predefined EVN, which is known as u201cvnet globalu201d was configured. What is the purpose of this EVN?
A. It defines the routing scope for each particular EVN edge interface.
B. It aggregates and carries all dot1q tagged traffic.
C. It refers to the global routing context and corresponds to the default RIB.
D. It safeguards the virtual network that is preconfigured to avoid mismatched routing instances
Answer: C
Question No: 14
Which type of information is displayed when a network engineer executes the show track 1 command on the router?
A. information about the IP route track table.
B. time to next poll for track object 1
C. information about tracking list 1
D. tracking information statistics.
Answer: C
Question No: 15
Which of the following are characteristics of TACACS+? (Choose two.)
A. Uses UDP
B. Encrypts an entire packet
C. Offers robust accounting
D. Cisco-proprietary
Answer: B,D
Explanation: EXPLANATION/REFRENCE CHARACTERISTICS O TACACS+
1-TACACS+ encrypts the entire body of the packet 2- TACACS+ uses TCP
3-TACACS+ uses the AAA architecture, which separates AAA 4-TACACS+ offers multiprotocol support.
5- TACACS+ is Cisco proprietary protocol
6- TACACS+ is a heavy-weight protocol consuming more resources 7-TACACS+ uses TCP port 49
8-Mainly used for Device Administration 9-TACACS+ supports 15 privilege levels
http://www.cisco.com/c/en/us/support/docs/security-vpn/remote-authentication-dial-user-service-radius/13838-10.html7
Question No: 16
Which DSL encapsulation method requires client software running on the end-user PC that is directly connected to a DSL modem?
A. PPPoA
B. PPPoE
C. PPP
D. L2TP
E. ATM
Answer: B
Question No: 17
After testing various dynamic IPv6 address assignment methods, an engineer decides that more control is needed when distributing addresses to clients. Which two advantages does DHCPv6 have over EUI-64 (Choose two.)
A. DHCPv6 requires less planning and configuration than EUI-64 requires.
B. DHCPv6 allows for additional parameters to be sent to the client, such as the domain name and DNS server.
C. DHCPv6 providers tighter control over the IPv6 addresses that are distributed to clients.
D. DHCPv6 does not require the configuration of prefix pools.
E. DHCPv6 does not require neighbor and router discovery on the network segment.
Answer: A,B
Question No: 18
On which two types of interface is Frame Relay switching supported? (Choose two.)
A. serial interfaces
B. Ethernet interfaces
C. fiber interfaces
D. ISDN interfaces
E. auxiliary interfaces
Answer: A,D
Question No: 19
To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.)
A. 192.168.30.1:0:0:0:0:0:0
B. 0:0:0:0:0:0:192.168.30.1
C. ::192.168.30.1 D. C0A8:1E01::
E. 192.168.30.1:: F. ::C0A8:1E01
Answer: B,C,F
Question No: 20
Refer to the following configuration command.
router(conttg)# ip nat inside source static tcp 172.16.10.8 8080 172.16.10.8 80 Which statement about the command is true?
A. Any packet that is received in the inside interface with a source IP port address of 172.16.10.8:80 is translated to 172.16.10.8 8:80
B. Any packet that is received in the inside interface with a source IP address of 172 16 10 8 is redirected to port 8080 or port 80
C. The router accepts only a TCP connection from port 8080 and port 80 on IP address 172 16 10 8
D. Any packet that is received in the inside interface with a source IP port address of 172 16 10 8 8080 is translated to 172.16.10.8 80
Answer: D
Explanation: http://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/13772-12.html#topic9
Recommend!! Get the Realistic 300-101 dumps in VCE and PDF From Dumpscollection, Welcome to download: http://www.dumpscollection.net/dumps/300-101/ (New 436 Q&As Version)