Ucertify offers free demo for 300-365 exam. "Deploying Cisco Wireless Enterprise Networks", also known as 300-365 exam, is a Cisco Certification. This set of posts, Passing the Cisco 300-365 exam, will help you answer those questions. The 300-365 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300-365 exams and revised by experts!


2026 New 300-365 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-365/

Q1. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three) 

A. verify that Global Multicast mode has been enabled 

B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients. 

C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth 

D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows 

E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet 

F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN 

Answer: A,B,E 

Q2. A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented. How should the engineer perform the password recovery? 

A. Use a console cable. 

B. Contact Cisco TAC and arrange an RMA of the MSE. 

C. Boot the MSE using the software installation DVD. 

D. The Password can be reset using Prime Infrastructure. 

Answer: A 

Q3. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this? 

A. Cisco MSE as NetFlow exporter 

B. Prime Infrastructure 1.0 or later 

C. Cisco NAC as NetFlow exporter 

D. Cisco ISE as NetFlow exporter 

Answer: B 

Q4. Which two options are limitations of using an AP as a workgroup bridge? (Choose two.) 

A. Only factory-configured MAPs can support WGB mode. 

B. MAPs that are configured in WGB mode do not answer S36 radio measurement requests. 

C. A limited subset of Layer 2 security types are supported for wireless clients of a WGB. 

D. There is a limit of 20 wired client devices. 

E. Multiple VLANs are not supported for wireless clients. 

Answer: B,D 

Q5. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group? 

A. 224.0.0.13 

B. 224.0.1.39 

C. 224.0.0.14 

D. 224.0.140 

Answer: D 

Q6. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead? 

A. 10 Seconds 

B. 60 Seconds 

C. 15 Seconds 

D. 30 Seconds 

Answer: D 

Q7. A customer has "quiet" wireless clients that use static IP addresses. Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.) 

A. Disable DHCP address assignment required. 

B. Enable passive client. 

C. Disable allow AAA override. 

D. Enable static IP tunneling. 

E. Disable DHCP server override. 

Answer: A,E 

Q8. An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area. Which two configuration options are required? (Choose two.) 

A. StaticCAC 

B. Admission Control 

C. Load-Based AC 

D. Add Traffic Stream 

E. Reserved Roaming Bandwidth 

F. Expedited Bandwidth 

Answer: B,C 

Q9. What is the best practice for setting the WLC v7.0 use of WLAN QoS settings to support SIP phones on a VoWLAN? 

A. Configure SIP with static CAC only with SIP call snooping. 

B. Configure SIP with static CAC only without SIP call snooping. 

C. Configure SIP with load-based CAC only with SIP call snooping. 

D. Configure SIP with load-based CAC only without SIP call snooping. 

E. Configure SIP with load-based CAC and TSPEC only with SIP call snooping. 

Answer: A 

Q10. A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple interfaces defined on the WLC and mapped to a single interface group. Which configuration meets this need? 

A. 264 interfaces of/25 sized networks 

B. 132 interfaces of/24 sized networks 

C. 66 interfaces of/23 sized networks 

D. 33 interfaces of /22 sized networks 

Answer: D