Proper study guides for Updated Cisco CCDE Written Exam certified begins with Cisco 352-001 preparation products which designed to deliver the Approved 352-001 questions by making you pass the 352-001 test at your first time. Try the free 352-001 demo right now.


2024 New 352-001 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/352-001/

Q1. Refer to the exhibit. 

You are designing a network using the Multiple Spanning Tree Protocol for loop avoidance. VLAN trunking is not allowed due to security requirements. Which option describes how you can design this Layer 2 network while using untagged interfaces between both switches? 

A. Assign VLAN 100 and VLAN 200 to the IST instance. 

B. Assign VLAN 100 and VLAN 200 to instance 1. 

C. Assign VLAN 100 to instance 1 and VLAN 200 to instance 2. 

D. Assign VLAN 100 to the IST instance and VLAN 200 to instance 1. 

Answer: C 

Q2. You are tasked with implementing a 1000-phone remote access solution, where phone calls will traverse a WAN edge router. Assuming all of the following features are supported in a hardware-assisted manner, which of the following will have the most negative impact 

on the delay of the packet? 

A. encryption 

B. stateful firewall 

C. MPLS encapsulation 

D. GRE encapsulation 

Answer: A 

Q3. ACME Corporation is deploying a new HR application that requires the network infrastructure to monitor and react to certain conditions in the network. Which feature should be used to meet this design requirement? 

A. Cisco IOS Embedded Event Manager 

B. IP SLA 

C. reflexive ACLs 

D. route maps 

E. SOAP 

F. exit status 

Answer: A 

Q4. Your company needs to baseline web traffic on a per-session basis for network application reporting. Which two mechanisms, when combined, fulfill the requirement? (Choose two.) 

A. Flexible Netflow 

B. Remote Monitoring 

C. Cisco IOS IP Service Level Agreement 

D. Class-Based Quality of Service Management Information Base 

E. Network-Based Application Recognition 

Answer: AE 

Q5. Which two features can be used to extend VRFs across a campus? (Choose two.) 

A. 802.1q trunks 

B. LDP 

C. MPLS TE 

D. GRE 

E. port channels 

Answer: AD 

Q6. Refer to the exhibit. 

You are developing a migration plan to enable IPv6 in your IPv4 network. Starting at R3 and assuming default IS-IS operations, what is likely to happen when you enable IPv6 routing on the link from R3 to R2? 

A. Only R3 and R2 have IPv4 and IPv6 reachability. 

B. R2 receives an IPv6 default route from R3. 

C. Loopback reachability between all routers for IPv4 is lost. 

D. All routers except R2 are reachable through IPv4. 

E. R3 advertises the link from R3-R2 to R1, R4 and R5 only. 

Answer: C 

Q7. A Service Provider network designer is considering the use of the G.8032 Ethernet Ring Protection mechanism in order to provide resiliency in the network. Which three concepts will be supported with the implementation G.8032? (Choose three.) 

A. Ring Protection Link (RPL) 

B. Ring Automatic Protection Switching (R-APS) 

C. Multi-Router Automatic Protection Switching (MR-APS) 

D. Automatic Protection Switching (APS) Channel 

Answer: ABD 

Q8. A company plans to establish a new network using Cisco Catalyst switches for its multicast applications. What is the disadvantage when two multicast applications are using the multicast IP addresses 234.17.4.5 and 234.145.4.5 inside the same network? 

A. Multicast packets from both applications are flooded to all Layer 2 ports in a segment where a multicast receiver is located. 

B. Multicast packets from both applications are flooded to ports where one multicast receiver from one application is located. 

C. Only one multicast stream is received at the port where the receivers from both applications are located. 

D. Both multicast senders will always receive the multicast packets from the other multicast application. 

E. The routers doing PIM-SM cannot distinguish between the two multicast applications. 

Answer: B 

Q9. Refer to the exhibit. 

This new OSPF network has four areas, but the hub-and-spoke area experiences frequent flapping. You must fix this design failure. Which two mechanisms can you use to isolate the data center area from the hub-and-spoke area without losing IP connectivity? (Choose two.) 

A. Make the DC area totally stub. 

B. Make the DC area an NSSA. 

C. Convert the DC area to EIGRP protocol. 

D. Deploy a prefix summarization on router D. 

E. Use OSPF distribute-list filtering on router A. 

Answer: AD 

Q10. Refer to the exhibit. 

You are asked to design this OSPF network to converge within 60 ms for unicast packets after a topology change due to a single link failure. Which technology can be enabled while conforming to the design requirements? 

A. Loop-Free Alternates 

B. BFD 

C. IGP neighbor timer tuning 

D. IGP SPF timer tuning 

E. RSVP-TE Fast Reroute 

Answer: A