It is impossible to pass Cisco 200-401 exam without any help in the short term. Come to Pass4sure soon and find the most advanced, correct and guaranteed Cisco 200-401 practice questions. You will get a surprising result by our Far out Managing Industrial Networks with Cisco Networking Technologies practice guides.


2026 New 200-401 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-401/

Q1. - (Topic 4) 

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop? 

A. router#ping 

B. router#tracert 

C. router#show ip route 

D. router#show cdp neighbors 

E. router#traceroute 

Answer: E 

Q2. - (Topic 4) 

A network administrator has subnetted the 172.16.0.0 network using a subnet mask of 

255.255.255.192. A duplicate IP address of 172.16.2.120 has accidentally been configured on a workstation in the network. The technician on the plant floor must assign this workstation a new IP address within that same subnetwork. Which address should be assigned to the workstation? 

A. 172.16.1.80 

B. 172.16.2.80 

C. 172.16.1.64 

D. 172.16.2.64 

E. 172.16.2.127 

F. 172.16.2.128 

Answer: B 

Q3. - (Topic 2) 

EtherNet/IP is an Ethernet implementation of which protocol? 

A. CIP 

B. Industrial Protocol 

C. DeviceNet 

D. ControlNet 

Answer: A 

Q4. - (Topic 4) 

At which Layer would you check for spanning tree loops? 

A. Layer 1 

B. Layer 2 

C. Layer 3 

D. Layer 4 

Answer: B 

Q5. - (Topic 1) 

Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.) 

A. The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so.shielded cable that is rated for 600 V.is advised. 

B. EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN. 

C. CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting. 

D. EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter. 

E. Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting. 

F. IEEE1588 and PTP are important for ensuring real-time synchronization. 

Answer: A,D,F 

Q6. - (Topic 5) 

Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used? 

A. hop count 

B. administrative distance 

C. link bandwidth 

D. link delay 

E. link cost 

Answer: B 

Q7. - (Topic 5) 

What is a reason to use user EXEC mode on an industrial switch? 

A. to verify commands that you have entered 

B. to change terminal settings 

C. to configure VLAN parameters 

D. to configure parameters that apply to the entire switch 

Answer: B 

Q8. - (Topic 4) 

With a Cisco IE 2000 switch, what does a port status LED indicate when it is solid green? 

A. The port is sending or receiving data. 

B. A link is present. 

C. No link is present. 

D. There is a link fault. 

E. The port is not forwarding. 

Answer: B