Improve 200-401 Exam Study Guides With New Update Exam Questions

Q1. - (Topic 2) 

Exhibit: 

Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each VLAN 1 interface has been assigned the correct IP address. What is the purpose of assigning a default gateway to SW-C switch? 

A. allows connectivity between the VLAN 1 interface on SW-C and other devices in the network. 

B. allows connectivity between Host A and other devices in the network. 

C. allows connectivity between Host B and other devices in the network. 

D. allows the switch to pass traffic between Host A and Host B 

View Answer

Q2. - (Topic 4) 

What are two recommended tools or commands that allow you to troubleshoot connectivity between two devices in different IP networks? (Choose two.) 

A. show interface status 

B. show spanning-tree 

C. ping 

D. show interfaces gigabitEthernet x/y switchport 

E. traceroute 

F. show interface 

View Answer

Q3. - (Topic 2) 

Which two ports does EtherNet/IP use to communicate? (Choose two.) 

A. TCP 44818 

B. UDP 44818 

C. TCP 502 

D. UDP 502 

E. TCP 2222 

F. UDP 2222 

View Answer

Q4. - (Topic 2) 

EtherNet/IP is an Ethernet implementation of which protocol? 

A. CIP 

B. Industrial Protocol 

C. DeviceNet 

D. ControlNet 

View Answer

Q5. - (Topic 5) 

What is a reason to use user EXEC mode on an industrial switch? 

A. to verify commands that you have entered 

B. to change terminal settings 

C. to configure VLAN parameters 

D. to configure parameters that apply to the entire switch 

View Answer

Q6. - (Topic 3) 

Which characteristic causes multimode fiber-optic cable to differ from single mode? 

A. by allowing multiple network services in the same cable 

B. shorter maximum network segment length for a given bandwidth 

C. a wider variety of available connector types 

D. use outdoors as well as indoors 

View Answer

Q7. - (Topic 4) 

At which Layer would you use trace route to validate the path? 

A. Layer 1 

B. Layer 2 

C. Layer 3 

D. Layer 4 

View Answer

Q8. - (Topic 5) 

What is the most critical step to perform when you are using optical fiber connectors? 

A. Cover with dust caps when not in use. 

B. Immerse in alcohol prior to use. 

C. Blow off and carefully wipe down with a tissue before and after each use. 

D. Lightly sand with cloth prior to mating. 

View Answer

Q9. - (Topic 1) 

Exhibit: 

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B. Which address is the default gateway of Host 3? 

A. the address of the switch interface that is connected to router interface Fa0/0 

B. the address of the switch interface that is connected to router interface Fa0/1 

C. the address of the host that is connected to Network A 

D. the address of the host that is connected to Network B 

E. the address of the router interface Fa0/0 

F. the address of the router interface Fa0/1 

View Answer

Q10. - (Topic 3) 

What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables? 

A. terminate in their characteristic impedance 

B. trim back and properly insulate 

C. connect to protective earth 

D. splice to a used conductor 

View Answer