Latest Cisco 300-365 braindumps

Q1. CMX Facebook WiFi can allow access to the network before authentication. Which two of the following options are available? (Choose two) 

A. Allow all the traffic before authentication and intercept HTTPs only. 

B. Allow HTTP traffic only before authentication and block all the traffic. 

C. Allow SNMP traffic only before authentication and block all the traffic. 

D. Allow all the traffic before authentication and intercept HTTP only. 

E. Allow HTTPs traffic only before authentication and block all other traffic. 

View Answer

Q2. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause of the drop in video? 

A. Clients are roaming at lower data rates and are not maintaining 36Mbps connectivity. 

B. Clients are not roaming due to coverage. This is causing the multicast data to drop due to the client re-associating often. 

C. Clients are connected at 18Mbps; however, other clients are connecting at 12Mbps and are causing the multicast video to degrade. 

D. Clients are maintaining a 12Mbps rate and cannot receive the stream at 18Mbps. 

View Answer

Q3. Refer to Exhibit. 

A wireless client is connecting to FlexAPI which is currently working standalone mode. The AAA authentication process is returning the following AVPs: 

Tunnel-Private-Group-ld(81): 15 Tunnel-Medium-Type(65):IEEE-802(6) Tunnel-Type(64): VLAN(13) 

Which three behaviors will the client experience? (Choose three.) 

A. While the AP is in standalone mode, the client will be placed in VLAN 15. 

B. While the AP is in standalone mode, the client will be placed in VLAN 10. 

C. When the AP transitions to connected mode, the client will be de-authenticated. 

D. While the AP is in standalone mode, the client will be placed in VLAN 13. 

E. When the AP is in connected mode, the client will be placed in VLAN 13. 

F. When the AP transitions to connected mode the client will remain associated. 

G. When the AP is in connected mode, the client will be placed in VLAN 15. 

H. When the AP is in connected mode, the client will be placed in VLAN 10. 

View Answer

Q4. A customer has implemented a wireless network that requires tuning for High Density applications utilizing the RX-SOP feature. They are experiencing a high noise floor (average of -65 dBm) and expect that to decrease significantly. A sampling of radios determine that most Access Points have neighbors on the same channel at a power level of -75 dBm. Which value should the customer use to start tuning RX-SOP? 

A. -60 dBm 

B. -65dBm 

C. -70 dBm 

D. -75 dBm 

E. -80 dBm 

View Answer

Q5. After implementing mDNS gateway, a school's network administrator notices that mDNS wireless printers are available over the whole network. Which feature can the admin use to restrict the printer mDNS advertisements to the AP that the printer is joined to and adjacent APs? 

A. mDNS-AP 

B. SSO 

C. LSS 

D. Priority MAC 

View Answer

Q6. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three) 

A. verify that Global Multicast mode has been enabled 

B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients. 

C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth 

D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows 

E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet 

F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN 

View Answer

Q7. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking? 

A. Uses existing LWAPP-enabled Cisco Unified Networking components. 

B. Proprietary client hardware or software is required. 

C. Better accuracy and precision. 

D. Reduced calibration effort. 

View Answer

Q8. You are deploying a combination of Cisco Unified Wireless IP Phones 7921G and 7925G at your branch offices in a centralized call processing environment that requires high availability at branch locations. Which three components need to be verified before the wireless IP phones can be deployed? (Choose three.) 

A. Sufficient SRST license support at each branch location 

B. Support for local voice mail 

C. Branch gateways support MoH 

D. Properly configured QoS over the IP WAN links 

E. Support for single number reach 

F. Support for E.164 dialing 

G. Sufficient IP phone licenses in the Cisco Unified Communications Manager cluster 

View Answer

Q9. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used? 

A. One interface with /20 mask 

B. Two interfaces with /21 mask 

C. Four interfaces with /22 mask 

D. Eight interfaces with /23 mask 

View Answer

Q10. You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC? 

A. central switching with PMK (OKC) between different FlexConnect groups 

B. local switching with Cisco Centralized Key Management within the same FlexConnect group 

C. central switching with Cisco Centralized Key Management between different FlexConnect groups 

D. local switching with PMKID within the same FlexConnect group 

View Answer