how many questions of 300-370 examcollection?

Q1. An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications? 

A. rogue AP containment 

B. RF detection 

C. switch port tracing 

D. wire detection 

E. Cisco Prime Infrastructure location services 

View Answer

Q2. A Wireless LAN Cisco engineer is troubleshooting 802. 11ac WLAN at customer site Doe to interferences with neighboring 802 11n networks the engineer must determine the current primary secondary channel allocation to enhance the current configuration. Channel 60 has been chosen by the customer as primary 20 MHz channel. Which combination determines the resulting primary 40 MHz and primary 80 MHZ channels? 

A. primary 40 MHz channel 62, primary 80 MM: channel 58 

B. primary 40 MHz channel 54, primary 80 MHz channel 58 

C. primary 40 MHz channel 64, primary 80 MHz channel 60 

D. primary 40 MHz channel 60, primary 80 MHz channel 56 

View Answer

Q3. Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages? 

A. debug pm pki enable 

B. debug cert events enable 

C. debug capwap events enable 

D. debug capwap packet enable 

E. debug capwap errors enable 

View Answer

Q4. An AP will be deployed to an area where DHCP Option 43 is unavailable and the WLAN engineer is unable to have DNS modifications made to support this AP. Which two actions can enable the AP to join the WLC? (Choose two) 

A. Issue the clear capwap private-config command in the AP console. 

B. Pre-stage or prime the AP on the same Layer 2 VLAN as the WLC. 

C. Issue the capwap ap ip default-gateway WLC IP address command in the AP console. 

D. Issue the capwap ap ip address WLC IP address command in the AP console. 

E. Issue the capwap ap controller ip address WLC IP address command in the AP console. 

View Answer

Q5. Some users are experiencing inconsistent performance on their mobile devices as they move throughout the building when browsing the Internet. Which feature provides a more consistent user experiences? 

A. low RSSI check 

B. 802.11r 

C. RX-SOP 

D. optimized roaming 

View Answer

Q6. An engineer is troubleshooting non-802 11 interference and observes this output. Which type of interference signatures can be identified? 

Refer to the exhibit. 

A. one frequency hopping Bluetooth 

B. two healthy CCK and one malformed OFDM 

C. three broadband jammers 

D. two strong microwave ovens and one moderate 

View Answer

Q7. Access points ate deployed in an office building and users report that the real-time communications quality of experience is poor when users walk between the elevators The elevators are a heavy metallic obstacle, and AP 3 was installed to cover the elevator area, which AP t and AP 2 signal does not reach Communications are captured for a user walking from point A to point C. and it is observed that the user iPhone device suddenly scans all bands and then roams from AP I to AP 3 somewhere between points B and C WLAN is set to 5 GHz only. Open, default rate configuration. Which action improves the real-time application quality of experience in this area? 

Refer to the exhibit. 

A. Enable 802 11v on the WLAN 

B. Enable 802 11r on the WLAN 

C. Enable 802 11k on the WLAN 

D. Move AP 2 to point B 

View Answer

Q8. An engineer is deploying a wireless infrastructure and must use Layer 2 discovery for access point association. Which configuration meets this requirement? 

A. Configure the Access Points and WLC management interface on the same VLAN. 

B. Configure a DNS A RECORD to point to the controller. 

C. Configure option 43 on The APs DHCP scope. 

D. Configure the AP using a serial connection to indicate its controller. 

View Answer

Q9. An engineer has configured 802 1x for the network and all but one of the APs are passing authentication. Which configuration is causing the failure? 

A. The AP has override global credentials checked. 

B. The switch AAA credentials do not match what is configured on ISE. 

C. The controller 802 1x supplicant credentials do not match what is configured on ISE 

D. EAP-FAST is configured on ISE for this AP. 

View Answer

Q10. Refer to the exhibit. 

A client reports being unable to log into the wireless network According to the output, which network information should be verified? 

A. the Failed Attempts log on the authentication server 

B. that the AP has IP connectivity to the authentication server 

C. that the user has an account on the authentication server 

D. that the authentication and accounting configuration are correct 

View Answer